Redline Composites

Lighter.Stronger.Built to spec.

Carbon fiber & fiberglass parts

For Motorsports work, Medical and Aerial programs

Red Line Composites

Built in the shop, not bought off a shelf

Red Line Composites builds composite parts to order. Intake ducts, housings, panels, brackets and fairings in carbon fiber and fiberglass, patterned from your part or drawing, laid up and finished in one shop.

Start a projectSee the work
A Red Line Composites cap on the shop bench beside a trimmed composite panel and an aluminum mold

What we build

Parts by program

Motorsports work: a composite part on the shop bench
Motorsports work
Program 01 · 8 pieces

Intakes, ducting, aero and chassis components for race programs.

More motorsports work

What we offer

  • 0101

    Pattern & tooling

    We work from your part, your CAD or a sketch and build the molds the layup needs, so the finished piece matches the one you asked for.

  • 0202

    Layup & cure

    Carbon fiber and fiberglass laid by hand in the shop and cured into a stiff, light, structural part.

  • 0303

    Trim, drill & finish

    Trimmed to the drawing, drilled to your hardware, finished in the surface the job calls for, from raw weave to gloss black.

  • 0404

    One-offs to short runs

    A single replacement for a part that no longer exists, a prototype, or a repeatable short run off the same tooling.

One shop.Every step.

Pattern, tooling, layup, cure and finish happen on the same floor. That is how a part that fits the drawing also fits the car, the device or the airframe it was drawn for.

Contact us

Start a project

Tell us about your part

A one-off, a short run or a replacement for a part that no longer exists. Send what you have, a photo, a drawing or a description, and we'll take it from there.

Quantity